www.emachines.com | Setting up the optional stand |
Adjusting monitor height tension
The stand is factory adjusted to maintain the height for your monitor. However, if it does not stay in place when you let go, you need to change the stand’s height tension. You also need to adjust the stand if the amounts of force required to raise and lower the monitor are not equal.
To adjust your monitor’s height tension:
1Press the screwdriver access hole cap from below the base to remove it from the base.
Screwdriver access cap
2Insert a Phillips screwdriver through the access hole in the base and onto the height tension screw (on the back of the stand, in the slot above the USB In port).
Height tension screw
3Adjust the height tension screw so the monitor stays in place when you let go. If the monitor lowers by itself when you let go, turn the screw clockwise several complete turns. If the monitor rises when you let go, turn the screw
7