EMC 4K VA 20K VA UPS Technical Specifications, For model with 3 Phase in 1 Phase out

9. Technical Specifications

For model with 3 Phase in 1 Phase out

Tower model (with LCD display)		8K31	10K31	12K31	15K31		20K31
Capacity	Capacity (VA)	8000VA	10000VA	12000VA	15000VA		20000VA
	Capacity (W)	5600W	7000W	8400W	10500W		14000W
			208/360V, 220/380V, 230/400V, 240/415V(3Ф5W)
		Load Capacity		Voltage/Range		Load Capacity
	Voltage/Load	208~241V	0~25%

Environment

Shipping Weight kg	151.5 (333.3)		206.5 (454.3)	246.5 (542.3)
(lb) W/ ISOTR
Operating			0~40°C / 32~104°F
Temperature
Storage		-20~50°C / -4~122°F
Temperature
Altitude			3,500 meters max
Audible Noise (1			< 55 dB
meter from surface)
Relative Humidity		0 ~ 95% humidity, non-condensing

Input								312~478V		0~100%
		242~276V	0~40%
		277~311V	0~75%
	Frequency					50/60 Hz Auto Sensing
	Voltage (on battery)	100V, 110V, 115V, 120V / 208V, 220V, 230V, 240V +/-2% (Selectable Output Voltage)
	Frequency (on battery)						50 / 60 Hz +/-0.5%
	Transfer Time							0 ms
	Overload Recovery					Auto transfer to UPS
Output	High Efficiency mode					> 97 %
	(AC to AC)
	UPS Design			On-Line / Fully digitized microprocessor controlled
	Technology
	Output Wave Form							Sine wave
	Harmonic distortion				< 3% of T.H.D. at linear load
	Crest Factor					3 : 1
	Surge Protection					IEC61000-4-5 level 3
Protection	Overload Protection	125% for 1 minutes and 150% for 10 seconds 130% for 10 seconds and 150% for 1.5
and Filtering						seconds (On-battery)
	Short Circuit Protection	UPS output cut off immediately or input fuse / circuit breaker protection
	Visual Display (LED	UPS on(green), line-mode(green), battery mode(yellow), bypass(yellow), fault(red)
	model)
System	Visual Display (LCD	Input / output voltage, input / output frequency, on-line mode, back up mode, battery
	model)						capacity, load level
Display/
	Audible Alarm (Battery							Beep every 5 sec
Warning
	back-up)
	UPS Fault			Continuous beeping sound and LCD display
	Communication				RS-232 Serial Port and USB
	Type			Sealed, maintenance-free lead acid batteries
	DC Voltage (V) Battery	240V /		240V /				240V /	240V /	240V /
		12V7.2AH x						12V7.2AH x 20 x	12V7.2AH x	12V9AH x 20
	(Tower )			12V9AH x 20
		20						2SET	20 x 2SET	x 2SET
	Typical Recharge Time							4 hours
Battery	to 90% Full
	Management		Self-test, adjustable battery transfer points and alarm settings
	Battery Protection			Cut off without draining any current when battery is low
	Cold Start (DC start)							YES
	Back Up Time (Tower			About 4~6 min Full load / 10~15min Half load
	model)
Physical	Input Inlet							Hardwire
	Receptacles							Hardwire
	Dimensions W x D x H	257 x 690 x 715						342 x 690 x 878	342 x 863 x 905
	mm (inch) W/O ISOTR	(10.1" x 27.2" x 28.1")					(13.5"x27.2"x34.6")		(13.5" x 34.0" x 35.6")
	Net Weight kg (lb) W/O	80.0 (176.0)					176.5 (388.3)		175.0 (385.0)
	ISOTR
	Shipping Weight kg (lb)	101.5 (223.3)					206.5 (454.3)		196.0 (432.3)
	W/O ISOTR
	Dimensions W x D x	342 x 690 x 715						342 x 690 x 878	342 x 863 x 905
	H mm (inch) W/
		(13.4" x 27.2" x 28.1")					(13.5"x27.2"x34.6")		(13.5" x 34.0" x 35.6")
	ISOTR
	Net Weight kg (lb)	130.0 (286.0)					176.5 (388.3)		225.0 (495.0)
	W/ ISOTR

For Tower model

Tower model (with LCD display)		VGD-4000		VGD5000		VGD-6000	VGD-8000
Capacity
	Capacity (VA)	4000VA		5000VA		6000VA	8000VA
	Capacity (W)	2800W		3500W		4200W	5600W
Output		208V, 220V, 230V, 240V +/-2% (Selectable Output Voltage) For 4K / 5K / 6K
	Voltage (on battery)	100V, 110V, 115V, 120V / 208V, 220V, 230V, 240V +/-2% (Selectable Output Voltage)
				For 6K / 8K with output isolation transformer
	Frequency (on			50 / 60 Hz +/-0.5%
	battery)
	Transfer Time				0 ms
	Overload Recovery			Auto transfer to UPS
	High Efficiency	> 95 %				> 97 %
	mode (AC to AC)
	UPS Design		On-Line / Fully digitized microprocessor controlled
	Technology
	Output Wave Form			Sine wave
	Harmonic distortion			< 3% of T.H.D. at linear load
	Crest Factor				3 : 1
Protection and	Surge Protection					IEC61000-4-5 level 3
Filtering
	Overload	125% for 1 minutes and 150% for 10 seconds (On-line) 130% for 10 seconds and 150%
	Protection			for 1.5 seconds (On-battery)
	Short Circuit	UPS output cut off immediately or input fuse / circuit breaker protection
	Protection
System/Display	Visual Display	UPS on(green), line-mode(green), battery mode(yellow), bypass(yellow), fault(red)
/Warning	(LED model)
	Visual Display	Input / output voltage, input / output frequency, on-line mode, back up mode, battery
	(LCD model)			capacity, load level
	Audible Alarm			Beep every 5 sec
	(Battery back-up)
	UPS Fault			Continuous beeping sound and LCD display
	Communication			RS-232 Serial Port and USB
Battery	Type			Sealed, maintenance-free lead acid batteries
	DC Voltage (V)	120V / 12V7AH		120V / 12V9AH		240V / 12V7.2AH	240V / 12V7.2AH
	Battery (Tower )	x 10		x 10		x 20	x 20
	Typical Recharge			4 hours
	Time to 90% Full
	Management	Self-test, adjustable battery transfer points and alarm settings
	Battery Protection	Cut off without draining any current when battery is low
	Cold Start (DC				YES
	start)
	Back Up Time	4 min. Full load /		5 min. Full load /		About 4~6 min Full load / 10~15min Half load
	(Tower model)	10 min. Half load		13 min. Half load
Physical	Input Inlet			Hardwire
	Receptacles	IEC C13*8 ; C19*2				Hardwire
	Dimensions W x D	257*537*440				257 x 590 x 570	257 x 690 x 715
	x H mm (inch) W/O						(10.1" x 27.2" x
		(10.1”x21.1”x17.3”)				(10.1"x23.2"x22.4")
	ISOTR						28.1")

28 29