5.4 Default settings at the factory
On the LCD display you will find several of the UPS parameters to select. Default settings are as follows:
6. Computer and alarm connections
At the back of the UPS is an interface allowing direct communication with your computer system, the location of which can be found in figure 4. There is a RS232 serial data interface, one USB data interface and an emergency power off switch supplied. However,
Settings
Output Voltage Setting
Input/Bypass Voltage
Input/Frequency
HE Mode Setting
Free Run Mode
Bypass Enable/Disable at free run mode
Alarm silence
Site wiring alarm
External Battery pack setting
Selection
208/220/230/240 Vac
±10%
±2%
±5%
±7%
On/Off
On/Off
Disable/Enable
On/Off
Enable/Disable
0, 1, 2
Factory default
230V (FOR HV series)
±5%
Off
On
Disable
Off
Disable
0
the RS232 port cannot be used when the USB interface is in use.
In addition there is an optional interface slot that allows you to install different communications cards. It can be used parallel with either the RS232 or USB ports.
Currently there are two cards available for the optional interface slot. An SNMP/WEB card allows management and monitoring over a network or internet, and the AS/400 card allows voltage free relay contacts. Your local dealer will have more information about these option cards.
Connecting the UPS to a Computer
The communication device for the UPS and PC comes as a complete package with power management software. Only the communication cable provided with UPS may be used to connect to your computer, which is accomplished through the UPS RS232 port. Also ensure that the operating system on your computer is supported. Instructions provided in the power management software will help with this installation.
Other advanced power protection solutions such as SNMP are provided by your dealer.
RS-232 Standard Interface port
The
You may change default settings, but we recommend that this is done after installation and before starting up loads. Read UPS configurations in chapter 7.2 for more information.
identified in the following table.
Pin # | Signal name | Direction (re UPS) | Functions |
|
|
|
|
2 | TxD | Output | TxD Output |
|
|
|
|
3 | RxD | Input | RxD / Inverter Off Input |
|
|
|
|
5 | Common |
| Common |
|
|
|
|
6 | CTS | Output | Ac Fail Output |
|
|
|
|
8 | DCD | Output | Low Battery Output |
|
|
|
|
9 | RI | Output | +12 VDC Power |
|
|
|
|
| Caution! Max rated values 12Vdc/50mA | ||
Fig.4
16 | 17 |
