Inspection and Unpacking
Figure 10 Unpacking the Liebert CRV
197023 Rev. 4
3.5Removing the Unit from the Skid
! WARNING
Risk of
Read all of the following instructions before attempting to move, lift or remove packaging from the Liebert CRV.
! CAUTION
Risk of sharp edges, splinters and exposed fasteners. Can cause personal injury.
Only properly trained and qualified personnel wearing appropriate safety headgear, gloves, shoes and glasses should attempt to move, lift or remove packaging from the Liebert CRV or prepare the unit for installation.
1.Open the top panel door with the mounted control (refer to Figure 11).
2.Remove the bottom baffle panel assembly by removing the screws with a T30 Torx screwdriver.
3.Set the baffle panel assembly aside until the Liebert CRV is ready for it to be to reattached.
4.Close and latch the top panel door.
5.Place the ramp against the skid as shown in Figure 11.
6.Remove the orange clips from the plastic bag.
7.Insert clips into holes of the skid and ramp.
8.Remove the eight bolts, four on each side, that secure side
9.Lower the four stabilizer feet until the side
10.Remove the six bolts, three on each side), that secure the side
11.Remove the side
12.Remove the eight bolts, four on each side, that secure the lift block to the skid. The bolts can be removed using a 17mm socket wrench,
13.Remove the lift blocks from the skid.
14.Using the stabilizer feet, lower the unit to the skid.
15.Move the unit to its installation location. Two or more properly trained and qualified personnel are required to move the Liebert CRV to its installation location.
11 | Liebert® CRV™ |