Installation
This section describes how to connect the system to the speakers, a TV monitor with audio / video input jacks and other video components. You cannot connect this system to a TV monitor which does not have a video input connector. Be sure to turn off the power of each component before making the connections.
Unpacking
Check that you have the following items:
ŸMain unit (1).
ŸSubwoofer (1).
ŸSpeakers (5).
ŸRemote control (1).
ŸVideo cable (4 feet x 1).
ŸAM loop antenna (1).
ŸFM antenna (1).
ŸOwner’s Manual (1).
ŸQuick Set Up Guide.
Inserting Remote Control Batteries
You can control the system using the supplied remote. Insert two batteries by matching the + and - on the batteries with the markings in the battery compartment. When using the remote, point it at the remote sensor on the front panel of this system.
Notes:
ŸDo not leave the remote in an extremely hot or humid place.
ŸDo not use a new battery with an old one.
ŸDo not drop any foreign object into the remote casing, particularly when replacing the batteries.
ŸDo not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so many cause a malfunction.
ŸIf you will not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
ŸUse only the size and type of batteries specified.
ŸBe sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
ŸDo not mix different types of batteries together (e.g. Alkaline and
14
