Controls and Their Functions
1.Main POWER Switch
Turns the main system power on and off. This switch must be set to the ‘On’ position in order to operate the system by remote control. We suggest that you leave this switch in the ‘On’ position unless the system will not be used for an extended period of time.
2.Standby Power Switch
Turns the system on or off. (Main Power Switch must be in the ‘On’ position.)
3.STANDBY Power Indicator
Lights when the system is in the Standby (‘Off’) mode. Goes out when the system is in the Operating (‘On’) mode.
4.Remote SENSOR
Receives the commands from the remote control handset. Note: Aim the remote at this sensor while pressing the
buttons on the remote.
5.MASTER VOLUME Control
Raises or lowers the volume of all 6 speakers together.
6.MEMORY Button
Used to memorize CD tracks for programmed playback.
7.TV Function Selection
If you have connected the Audio Out jacks of your stereo TV to the TV/AUX INPUT jacks on the back of this unit, press the TV button to listen to the sound of your TV through the speakers of this system.
8.VIDEO Function Selection
If you have connected the Audio Out jacks of your stereo VCR to the VIDEO (AUDIO) INPUT jacks on the back of this unit, press the VIDEO button to listen to the sound of your VCR through the speakers of this system.
9.TUNER (Band) Function Selection
Press to select the Tuner function and listen to the radio. After selecting the Tuner function press the Tuner button again to switch between FM and AM bands.
10.DVD (CD) Function Selection
Press to select the DVD (or CD) playback modes.
11.MONO/ST. Mode Selector
When listening to the FM radio press to switch between FM Stereo and FM mono modes.
12.PAUSE ; (Step) Button
DVD - press to pause playback momentarily. When picture is paused, continue pressing Pause button to perform
CD - press to pause playback temporarily. The sound stops but the disc continues to spin. Press the Play button to cancel Pause and resume normal playback.
13.PLAY 4 Button
In DVD (CD) mode, press to begin playback. In Pause mode, press to cancel Pause and resume normal playback.
14.STOP < Button
Press to stop DVD or CD playback.
15.OPEN/CLOSE 
Button
Press to open or close the DVD/CD drawer to load or remove a disc.
16.SKIP Forward : Button
DVD - press to skip forward to higher numbered chapters on a DVD movie disc.
CD - press to skip forward to higher numbered tracks on an audio CD.
17.SKIP Reverse 9 Button
DVD - press to skip back to lower numbered chapters on a DVD movie disc.
CD - press to skip back to lower numbered tracks on an audio CD.
18.TUNING Up 5 / Down 6 Buttons
In Tuner mode, press these buttons to tune to higher or lower frequencies.
19.PRESET STATION Up 5 / Down 6 Buttons
In Tuner mode press these buttons to scroll up or down through the preset station memories.
20.SELECT Button
Use to adjust the amount of delay between the front and rear speakers. (see page 42)
21.SPEAKER SETUP Button
This button is used to change the frequency range distribution to the speakers. For example if you later decide to use full range speakers in place of the supplied front left and front right satellite speakers you may change the frequency range distribution so that bass sounds are also heard from the full range front speakers. (see page 42)
22.DSP MODE Button
Press to select among the various listening modes including, Dolby Digital, Dolby Surround Pro Logic, DTS, Dolby 3 Stereo, or 2 Channel Stereo modes. (see page 42)
23.NIGHT Mode Button
When playing a DVD movie with Dolby Digital soundtrack at night, at lower volume, switch the Night Mode function ‘On’ to narrow the dynamic range and make the soundtrack easier to hear at the reduced volume level.
21
