Emerson CF200n100 owner manual

BP7354 CF200 9/19/07 11:30 AM Page 6

4. Position the blade flange on the motor hub so that the screws in the blade flange align with the two threaded holes in the motor hub. Tighten the two screws securely. Repeat this procedure for the remaining two blade assemblies.

1/4-20 x 11mm PAN HEAD SCREW WITH LOCKWASHER (2)

BLADE

FLANGE

MOTOR HUB

be mated correctly (color-to-color) before they can be engaged. Make sure the connectors close properly.

7.Connect the white wires from the light fitter to the white wire in the switch housing (Figure 5). Connect the black wire from the light fitter to the blue wire in the switch housing.

LIGHT FITTER

WHITE WIRES

BLACK WIRE

BLUE

WIRE

Figure 3

5. Insert the motor connector through the center hole in the switch housing assembly (Figure 4). Position the switch housing so that the slotted holes align with the smaller threaded holes in the coupling. Then install three 8-32 x 12mm pan head screws with lockwashers (supplied). Install three 1/4-20 x 11mm pan head screws with lockwashers (supplied) in the larger threaded holes. Tighten the screws.

COUPLING	1/4-20 x 11mm PAN HEAD
	SCREW WITH LOCKWASHER
	8-32 x 12mm PAN HEAD
	SCREW WITH LOCKWASHER
	SWITCH HOUSING
	CONNECTOR

SWITCH HOUSING

ASSEMBLY

Figure 5

8. Position the light fitter into the switch housing assembly (Figure 6) so that the three mounting holes in the light fitter align with the three threaded holes in the switch housing. Install three 10-24 x 22mm pan head screws and tighten securely.

CAUTION: Before installing and tight- ening the screws, be sure there are no wires pinched between the light fitter and the switch housing.

10-24 x 22mm PAN HEAD SCREW (3)

MOTOR	LIGHT FITTER
CONNECTOR

SWITCH HOUSING

ASSEMBLY

Figure 4

6. Engage the connector of the switch housing assembly with the motor con- Figure 6 nector (Figure 4). The two connectors

are keyed and color-coded and must 6

SWITCH HOUSING

ASSEMBLY

U.L. Model No.: CF200