Emerson CF2800PW, CF2800WB, CF2800BS warranty turns into the switch housing cover Figure

14.Slightly separate the upper and lower fan blades and carefully seat the strut into the holes in the end of the fan blades (Figure 10). Secure the strut by installing two 6-32 x 6mm Phillips button head screws (supplied). Be careful not to scratch the blades.

6-32 x 6mm PHILLIPS BUTTON HEAD SCREWS (2)

STRUT

IMPORTANT: Perform steps 19 through 23 ONLY if you want to install your ceiling fan without the light fixture. If you want to install your fan with the light fixture, omit steps 19 through 23 and proceed to step 24.

19.Remove the nut and lockwasher securing the light fixture to the switch housing cover (Figure 12). Unscrew the light fixture from the switch housing cover. Retain the light fixture in case you want to install it later.

SWITCH HOUSING
COVER	REMOVE AND
REMOVE AND	RETAIN THIS
	LOCKWASHER
RETAIN THIS NUT

Figure 10

FAN BLADE

15.Grasp the blades and turn them over, then install the remaining four 6-32 x 6mm Phillips button head screws (supplied) to secure the struts.

Remove the masking tape securing the two blade flanges together. Repeat steps 12 through 15 for the remaining four blade assemblies.

16.Use the 10 round recessed holes in the motor hub marked with “5” and install the five blade assemblies in accordance with step 17.

17.Attach one blade assembly to the motor hub using two 10-32 x 1” oval head screws (supplied) (Figure 11). Do not tighten completely at this time. Install four remaining blade assemblies in the same way. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation.

Figure 12 LIGHT FIXTURE

20. Screw the 2-1/4” pipe nipple (supplied) several full

turns into the switch housing cover (Figure 13).

Reinstall and tighten the lockwasher and nut onto

the nipple (Figure 13).

21. Pass the speed control switch chain from the

switch housing through the chain bushing in the

switch housing cover (Figure 13). Attach the

speed control pendant to the pull chain using a

plastic coupler.

22. Make sure all wires and wire connectors are

inside the switch housing, then position the switch

housing cover on the switch housing so that the

two 8-32 x 3/8” pan head screws (previously

installed) protrude through the keyhole slots in the

switch housing cover. Turn the switch housing

cover clockwise to engage the slots, then

8-32 x 3/8"

PAN HEAD SCREWS (2)

SWITCH

HOUSING

Figure 11

10-32 x 1" OVAL HEAD SCREW (2 per blade assembly)

MOTOR HUB

securely tighten the two screws (Figure 13).

NOTE: Be sure the wires are not pinched between the switch housing and the switch housing cover.

SWITCH HOUSING COVER

2-1/4" PIPE NIPPLE

REINSTALL

LOCKWASHER AND

NUT

SPEED CONTROL

SWITCH CHAIN

18.Partially screw two 8-32 x 3/8” pan head screws (supplied) into the threaded holes in the switch housing (Figure 11).

Figure 13

SPEED CONTROL	TIGHTEN TWO
	8-32 x 3/8"
PENDANT	PAN HEAD
	SCREWS

6