Emerson CF2800PW, CF2800WB, CF2800BS Unpacking Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One wire stripper
One stepladder	Masking tape
Three wire connectors (supplied)

MATERIALS

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

8.Three wire connectors

9.Two pull chain pendants

10.Two plastic couplings

11.One hairpin clip

12.One clevis pin

13.Eleven 10-32 x 1” oval head screws

14.Thirty-two 10-32 x 8mm Phillips button head screws

15.Forty-two 6-32 x 6mm Phillips button head screws

16.One fiber washer

17.Two 8-32 x 3/8” pan head screws

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

AHI

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a. Fan motor and housing assembly

b. One motor cover

c. Once ceiling cover

d. Ten fan blades

e. Five upper blade flanges

f. Five lower blade flanges

g. Ten struts

J

L

M

KN

B

F

h. One hanger ball/downrod assembly
i. One hanger bracket
j.	One switch housing cover/light fixture assembly
k. One cover plate
l.	One light fixture glass

E G

m.One finial nut
n. One loose parts bag containing:
1.	One 5/16-18 x 1/4” setscrew
2.	One setscrew wrench
3.	One 2-1/4” pipe nipple
4.	Two 1” threaded studs
5.	Two 1-1/4” threaded studs
6.	Four knurled knobs

7. Four lockwashers 3

D

C