Emerson CF2800PW, CF2800WB, CF2800BS warranty Using Your Ceiling Fan, Three-Speed

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

3.Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 20).

4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 20).

5.Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 21.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.

CEILING COVER

LOCKWASHERS (2)

KNURLED KNOBS (2)

1-1/4"

THREADED STUDS (2)

Figure 21

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

6.Screw three candelabra base lamps (60-watt each max.) in the light fixture sockets. Pass the light fixture switch chain through the light fixture glass (Figure 22). Position the glass on the light fixture so that the three elongated points of the glass are over the three lamps. Install the fiber washer and the finial nut (supplied) to hold the glass on the light fixture. Securely tighten the finial nut.

7.Slip the speed control switch pull chain through the hole in the oval pendant (supplied), then secure the pendant by snapping the plastic coupling (supplied) onto the end of the chain (Figure 22). Repeat this procedure to connect the pendant to the light switch pull chain.

60-WATT

CANDELABRA

SOCKET (3) BASE LAMP (3)

LIGHT FIXURE

GLASS	FIBER WASHER
SPEED
CONTROL	FINIAL NUT
PENDANT
PLASTIC	LIGHT FIXTURE
COUPLING
	PENDANT
	PLASTIC
	COUPLING
Figure 22

Using Your Ceiling Fan

1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

2.Check the operation of the fan by gently pulling on the 4-position speed control switch pull chain. The operating sequence is as follows:

THREE-SPEED
1st Pull—HIGH	3rd Pull—Low
2nd Pull—Medium	4th Pull—OFF

3.If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then press the rocker switch located on top of the motor housing, and turn the fan on again (Figure 23). The fan blades will turn in the opposite direction and reverse airflow.

4.Check the operation of the light fixture by gently pulling the light switch pull chain.

REVERSING SWITCH

TOP OF

HOUSING

SPEED CONTROL
SWITCH PULL	LIGHT SWITCH
CHAIN
	PULL CHAIN
Figure 23

9