Emerson CF3200AWL00 owner manual Operating Your Ceiling Fan

Operating Your

Ceiling Fan

IMPORTANT

Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.

NOTE: The downlight button will not work unless an Emerson light kit is added to the ceiling fan.

Your SW116 Fan/Light Wall Control (Figure 30) has full control of your fan, lights, and airflow direction.

1.To set the desired fan speed, push the HI, MED, or LOW buttons to operate your fan on high, medium or low speed (See Figure 30).

2.To reverse the direction the fan is turning, press the REV button. The direction the fan turns will change each time the REV button is pressed.

3.To turn your fan off, press the FAN OFF button.

4.To set the level of light brightness, press and hold the U/L (uplight) button or the D/L (downlight) button (if downlight kit is added to fan). The light brightness will continue to increase then decrease while the button is held down. When the light is at the desired brightness, release the button.

5.To turn the lights on and off, press and release the U/L (uplight) button or the D/L (downlight) button (if downlight kit is added to fan). The lights will turn on at the light level previously set (see Step 4).

Red light turns on when any button is pressed. If the light does not come on, replace your battery.

			RED
			INDICATOR
FAN			LIGHT
SPEED	HI		LIGHT
BUTTONS		U/L	BUTTON
		LIGHT	AIRFLOW
	MED		DIRECTION
		D/L
FAN OFF			BUTTON
	LOW	REV
BUTTON	FAN OFF

Figure 30

INSTRUCTION TO THE USER (if device contains a digital device)

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if no installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is not guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

12 U.L. Model No.: CF3200