WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
| OUTLET |
| BOX |
TWO SCREWS |
|
SUPPLIED WITH | HANGER |
OUTLET BOX | |
| BRACKET |
Figure 21 | TAB |
2.Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 22). Be sure the groove in the ball is lined up with tab on the hanger bracket (Figure 21).
WARNING
Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.
NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES OMITTED FOR CLARITY.
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
Figure 22
WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and the hanger bracket.
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan and light kit or receiver.
1.Pull the wire leads, coming from the end of the downrod, and the supply wires through the open side of the hanger bracket. (Figure 23).
2.Position the SW105 Receiver (supplied) in the ceiling cover so that the flat side of the receiver faces up and the open portion of the receiver is to the right, as shown in Figure 23.
9
3.Using wire connectors (supplied), make wiring connections as follows (Figure 23 and 24):
a.Connect the white fan wire and the white supply wire to the white receiver wire (AC IN/ MOTOR N).
b.Connect the black fan wire to the black receiver wire (TO MOTOR L).
c.Connect the black supply wire to the black/white receiver wire (AC IN L).
d.Cut off the ends of the blue and yellow receiver wires and strip back insulation
e.Connect the blue fan wire to the blue receiver wire (BOTTOM LIGHT).
f.Connect the yellow fan wire to the yellow receiver wire (UPPER LIGHT).
g.Connect the green ground wires from the hanger bracket and the hanger ball to the supply ground wire (bare or green).
