Emerson CF3400AP, CF3400ORH owner manual Read and Save These Instructions

READ AND SAVE THESE INSTRUCTIONS

Installation Instruction on

New CSA Hanging Device

INSTALLATION INSTRUCTIONS

Always properly install the ceiling fan mounting plate to a structural ceiling joist that is capable of reliably supporting at least 50 pounds.

PRELIMINARY PROCEDURES FOR

EXTRA SUPPORT HANGING SYSTEM

WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

1.Slip the loop of the short steel support cable onto the flat washer, lockwasher and 2” lag screw (supplied). Attach the short steel support cable through the center hole of the outlet box into the supporting joist by securely tightening the flat washer, lockwasher and 2” lag screw (Figure 1). The support cable lag screw must be installed such that it is structurally independent of the outlet box. Pre-drill the support joist with a 9/64” diameter drill to prevent splitting the joist.

OUTLET BOX ELECTRIC

DRYWALL CEILING

FLAT WASHER,	SHORT STEEL
LOCKWASHER, &	SUPPORT CABLE
2" LAG SCREW

OUTLET BOX

CENTER HOLE

LOOP
FLAT WASHER
LOCKWASHER	JOIST

2" LAG SCREW

SHORT STEEL SUPPORT CABLE

Figure 1

2.Pull the electrical supply wires and support cable through the center opening of the ceiling cover (Figure 2).

CEILING

COVER

HANGER BRACKET

	TAB
Figure 2	MOUNTING SCREW (2)

3.Install the ceiling cover and hanger bracket together onto the outlet box using the two screws supplied with the ceiling fan. Discard the screws that were supplied with the electrical box. The hanger bracket will nest into the ceiling cover between the raised guides on the bottom surface of the cover. The center hole of the ceiling cover provides visual access to view installation of the outlet box screws into the threaded mounting holes of the box (Figure 3).

WARNING

To avoid possible fire or shock, do not pinch electrical wires between the ceiling cover and hanger bracket, or the electrical box and the ceiling cover.

4.Pull the electrical supply wires and support cable through the opening on the back side of the hanger bracket for installation of the fan’s hanger ball.