3. Pull the electrical supply wires through
the opening on the back side of the
hanger bracket for installation of the
fan’s hanger ball.
4. To prevent scratching the fan assembly,
secure the upper motor cover onto a
blade flange with masking tape.
5. Carefully lift the fan assembly and
install the fan’s hanger ball into the
hanger bracket. For added clearance,
position the fan’s reverse switch to the
side of the hanger bracket during
installation.
6. Carefully rotate the fan assembly to
engage the hanger ball groove onto the
hanger bracket locking tab. When
locked in position, the fan will not rotate
on the hanger bracket.
5Model No.: CF3400
CEILING
COVER
HANGER BRACKET
MOUNTING SCREW (2)
TAB
Figure 2
GREEN GROUNDING
LEAD FROM THE
HANGER BALL
HANGER BRACKET
HANGER BALL
GREEN GROUNDING LEAD FROM
THE HANGER BRACKET
Figure 3
1. Pull the electrical supply wires through
the center opening of the ceiling cover.
2. Install the ceiling cover and hanger
bracket together onto the outlet box
using the two screws supplied with the
outlet box. The hanger bracket will nest
into the ceiling cover between the
raised guides on the bottom surface of
the cover. The center hole of the ceiling
cover provides visual access to view
installation of the outlet box screws into
the threaded mounting holes of the box
(Figure 2).
This product is designed to use only
those parts supplied with this product
and/or any accessories designated
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
!WARNING
1. Connect the green grounding lead from
the hanger ball and the green
grounding lead from the hanger bracket
to the grounding conductor of supply
(this may be a bare wire or wire with
green colored insulation) with wire
connector supplied. (Figure 3.)
Failure to seat tab in groove could cause
damage to electrical wires and possible
shock or fire hazard.
!WARNING
To avoid possible fire or shock, do not
pinch wires between the hanger
ball/downrod assembly and hanger
bracket.
!WARNING
To avoid possible fire or shock, do not
pinch electrical wires between the ceiling
cover and hanger bracket, or the
electrical box and the ceiling cover.
!WARNING
If you feel that you do not have enough
electrical wiring knowledge or exper-
ience, have your fan installed by a
licensed electrician.
NOTE: Pivot the fan on its mounting
ball to improve access to the top of the
motor when making electrical con-
nections with supply wires (Figure 3).
How to WireYour Ceiling Fan
BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 5