BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 7
BLADE
MEDALLION
OVAL HEAD SCREW
(3 per blade assembly)
BLADE
(Sold Separately)
MEDALLION BOSS (3 per medallion)
1. Remove the wall plate and screws from the existing wall switch. Pull switch out from wall outlet box.
2. Disconnect wire from existing fan wall switch (Figure 7).
3. Slide the fan control to the OFF position
(0).
WALL OUTLET BOX 
Figure 6
2. Assemble the remaining blade per previous instructions.
NOTE: Take care not to scratch fan blades during installation.
How to Wire Your Ceiling Fan - SW46 Wall Control
This control is designed to operate only one ceiling fan.
!
WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
SWITCH
Figure 7 | WALL PLATE |
|
4. Connect one BLACK wire from the fan control to the fan/motor load wire with a wire connector (provided) (Figure 8).
5. Connect the other BLACK wire from the Fan Control to the 120VAC hot supply wire with a wire connector (provided with control).
NOTE: Use wire connectors (supplied) to secure electrical connections.
6. If present, connect the supply white neutral wire to the branch circuit white neutral wire with a wire connector.
!
WARNING
To avoid possible fire or shock, follow all wiring instructions carefully. Any Electrical work not described in these instructions should be done or approved by a licensed electrician.
!
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
!
WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker panel.
NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advise, as it must be grounded for safe operation.
7 | Model No.: CF3400 |
