Emerson CF3900BS01 Unpacking and Assembly Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
Three wire connectors (supplied.)	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking and Assembly Instructions

For your convenience, check-off boxes are provided next to each step. As each step is com- pleted, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or acces- sories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1. Open styrofoam unit containing fan. Remove top

half of styrofoam unit. Remove parts and check to

see that you have received the following:

a. Fan motor and housing assembly

b. One motor cover

c. One ceiling cover

d. Five blade flanges

e. One hanger ball/downrod assembly

f. One hanger bracket

g. One housing switch cup

h. One loose parts bag containing:

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

NOTE: Fan blades are ordered separately and are packaged in a separate carton.

CEILING	BLADE
COVER
	FLANGES

LOOSE

PARTS BAG

FOAM
PACKING	HANGER	HANGER BALL/
	BRACKET
		DOWNROD
		ASSEMBLY
	MOTOR AND
	HOUSING ASSEMBLY

MOTOR

PROTECTIVE COVER PLASTIC BAG

1.	One setscrew
2.	One 3/16" hex wrench
3.	Eleven 10-32 x 5/8" oval head screws
4.	Two 1” threaded studs
5.	Two 1-1/4” threaded studs
6.	Four knurled knobs
7.	Three wire connectors
8.	Four 8-32 x 5/16” flat head screws
9.	One pull chain pendant
10.	One pull chain coupling
11.	One hairpin clip
12.	One clevis pin
13.	Four lockwashers
14.	Sixteen 10-32 x 3/8" pan head screws
15.	Sixteen flat washers

FOAM PACKING

HOUSING SWITCH CUP

CARTON

4