Emerson CF3900TG01, CF3900WPB01, CF3900WW01, CF3900AB01, CF3900BQ01, CF3900BS01, CF3900AW01, CF3900OB01

9.The fan comes with blue, black and white leads that are 80-inches long. Before installing fan, mea- sure up approximately 6 to 9-inches above the ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

10.Use three 10-32 x 3/8" pan head screws and flat washers (supplied) to secure flange to blade, as shown below. Repeat for the remaining four blades.

10-32 x 3/8" PAN HEAD SCREW (3)

FLAT WASHER (3)

BLADE FLANGE

FAN BLADE

11.Use the 10 round recessed holes in the motor hub marked with "5" and install the five blade assemblies (ordered separately) in accordance with Step 12.

12.Attach one blade assembly to the motor hub using two 10-32 x 5/8" oval head screws (supplied). Do not tighten completely at this time. Install remain- ing blade assemblies in the same way. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this proce- dure could result in fan wobble. This completes the blade installation.

1/4-20 x 1/2"
FLANGE SCREWS (2)
(INSTALL THROUGH SLOT	SWITCH HOUSING
IN SWITCH HOUSING PLATE)	PLATE
	MOTOR
	HUB

13.Remove the fan motor and housing assembly from the styrofoam packaging. Position the motor so that the bottom of the motor is facing you. Engage the connector of the switch cup assembly with the motor connector by aligning the V-notch shaped keyways and pressing the connectors firmly together until they fully mate. The V-notch keyways prevent the connectors from being engaged improperly.

	SWITCH	MOTOR
SWITCH HOUSING	HOUSING	CONNECTOR
	CONNECTOR

ASSEMBLY	SWITCH CUP
	CONNECTOR
	MOTOR
	CONNECTOR

14.Position the switch cup assembly on the motor switch plate and align the holes in the cup assem- bly with the holes around the side of the switch cup plate. Secure The switch cup assembly by installing three 8-32 x 3/8" flat head screws (supplied in loose parts bag).

!WARNING

To avoid possible fire or shock, do not pinch wires between the switch cup assembly and the switch cup plate.

SWITCH CUP

ASSEMBLY

8-32 X 3/8"
FLAT HEAD	SWITCH CUP
MOUNTING	PLATE
SCREWS (3)

SWITCH

HOUSING

ASSEMBLY

!WARNING

To reduce the risk of personal injury, do not bend the blade flanges when installing the blades or cleaning the fan. Do not insert foreign objects between rotat- ing fan blades.

6

SWITCH CUP PLATE

8-32 x 3/8"

FLAT HEAD MOUNTING SCREWS (3)