Assembly Instructions
1. | Remove the fan motor and housing assembly from |
| styrofoam packaging and position it so that the top |
| of the motor is facing you. |
2. | Separate, untwist and unkink the three motor |
| leads. Route the motor leads through the hanger |
| ball/downrod assembly and seat the downrod in the |
5.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod. Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 8.
motor coupling. |
3. Align the clevis pin holes in the downrod with the |
holes in the motor coupling. Install the clevis pin |
and secure with the hairpin clip. The clevis pin |
must go through the holes in the motor coupling |
and the holes in the downrod. Push the straight leg |
HANGER BALL
DOWNROD
PIN
SETSCREW
of the hairpin clip through the hole near the end of |
the clevis pin until the curved portion of the hairpin |
clip snaps around the clevis pin. The hairpin clip |
must be properly installed to prevent the clevis pin |
from working loose. Pull on the hanger ball to make |
sure the clevis pin is properly installed. |
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tight- ened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
HANGER BALL |
|
| DOWNROD |
| HAIRPIN |
SETSCREW | CLIP |
| |
CLEVIS PIN | MOTOR |
| COUPLING |
HANGER BALL/
DOWNROD
HAIRPINASSEMBLY
CLIP
CLEVIS | CLEVIS |
PIN | |
PIN | MOTOR COUPLING |
|
4.Install the setscrew (supplied in loose parts bag) in the motor coupling. While pulling up on the hanger ball, tighten the setscrew using the 5/32" setscrew wrench (supplied).
NOTE: The setscrew must be properly installed as described above, or fan wobble could result.
SETSCREW
DOWNRODWRENCH
6.Screw two 1” threaded studs (provided) into the motor. Leave approximately 7/8” of the stud extend- ing above motor. Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two knurled knobs (supplied) to secure the cover.
NOTE: Make sure the red and brown leads are capped with wire connectors and are completely inside motor cover and not pinched between the motor cover and motor.
| KNURLED | |
| KNOB | |
| MOTOR | |
| COVER | |
WIRE |
| |
CONNECTORS |
| |
| 1" THREADED | |
RED LEAD | STUD | |
MOTOR | ||
BROWN LEAD | ||
7/8" |
|
7.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large open- ing at the top.
8.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod. Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
PIN
HANGER BALL
DOWNROD
SETSCREW
CEILING COVER
5