How to Put Your Ceiling Fan Together
1.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5.
PIN |
HANGER |
BALL |
3.Tighten the two upper setscrews (Figure 2) securely while pulling up on the downrod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
4.Place the ceiling cover over the downrod, making sure that the large opening faces upward (Figure 3).
DOWNROD | SETSCREW |
|
Figure 1
2. Unscrew the two upper setscrews (Figure 2) until |
they clear the inside of the motor coupling. Then |
separate, untwist and unkink the three 80” motor |
leads. Route the motor lead wires through the |
downrod. Align the clevis pin holes in the downrod |
with the holes in the motor coupling. Install the |
DOWNROD
RETIGHTEN
UPPER
SETSCREW
Figure 3
CEILING
COVER
RETIGHTEN UPPER SETSCREW
clevis pin and secure with the hairpin clip (Figure |
2). The clevis pin must go through the holes in the |
motor coupling and the holes in the downrod. Be |
sure to push the straight leg of the hairpin clip |
through the hole near the end of the clevis pin until |
the curved portion of the hairpin clip snaps around |
the clevis pin. The hairpin clip must be properly |
installed to prevent the clevis pin from working |
loose. Pull on the downrod to make sure the clevis |
pin is properly installed. |
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews are securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figures 2 & 3) could result in the fan falling.
5.Reinstall the hanger ball on the downrod as follows (Figure 4) . Route the three 80” motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are proper- ly installed could result in the fan falling.
| MOTOR | |
DOWNROD | COUPLING | |
UPPER |
| |
SETSCREW (2) | HAIRPIN | |
CLEVIS PIN | ||
CLIP |
CLEVIS PIN
UNTIGHTEN
UPPER
SETSCREW
Figure 2
DOWNROD
CLEVIS PIN
HAIRPIN
CLIP
UNTIGHTEN
UPPER
SETSCREW
| PIN |
HANGER BALL |
|
DOWNROD | CEILING |
| COVER |
| SETSCREW |
Figure 4
6.The fan comes with blue, black and white leads that are
4