Emerson CF680WB00, CF680BQ00, CF680ORB00 warranty General Purpose

BP7305 Westfield 6/30/06 12:10 AM Page 11

			GENERAL PURPOSE	FAN SWITCH
LISTED OUTLET BOX			ON-OFF WALL
		BLACK FAN WIRE	SWITCHES OR
			OPTIONAL EMERSON	LIGHT
GREEN WIRE	BLACK	RED
			FAN/LIGHT CONTROLS			BLACK
(GROUND)				SWITCH
FROM						(HOT)
HANGER						TO 120
BRACKET		WHITE				VOLT
					WHT.	SUPPLY
GROUND
WIRE		BLUE		GROUND	GROUND

	GREEN WIRE (GROUND)
	FROM HANGER BALL
Figure 14	LISTED WIRE CONNECTOR (4)

THREE-CONDUCTOR CABLE (WITH GROUND) BETWEEN CEILING AND WALL OUTLET BOXES

3.If you are going to use a single wall switch or optional Emerson fan control to control your ceiling fan, housing lights, and optional Emerson Light Fixture (if installed) simultane- ously, you will need a standard two- wire (with ground) conductor cable between the ceiling and wall outlet boxes. The fan speed and the housing lights can then be operated from the pull chain switches in the switch cup housing (or by an optional Emerson fan control); the optional light fixture can be operated from the light fixture switch. Refer to Figure 15 and proceed as follows:

a.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the supply grounding conductor (this may be a bare wire or wire with green colored insulation). Securely connect wires with a wire connector (supplied).

b.Securely connect the fan motor white wire to the supply white

(neutral) wire using a wire connector (supplied).

c.Securely connect the fan motor black wire and blue wire to the supply black (hot) wire using a wire connector (supplied).

d.After connections have been made, separate the white and green wires from the black and blue wires.

e.Carefully turn the wires upward and insert them up through the open side of the hanger bracket and into the outlet box. Push the green and white wires into one side of the outlet box; push the black and blue wires into the other side of the outlet box.

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

11