BP7305 Westfield 6/30/06 12:10 AM Page 5
How to Assemble Your | 2. Remove and discard the four shipping | ||||||
| Ceiling Fan | retainers securing the motor hub in the | |||||
|
|
|
| motor housing. |
| ||
! | WARNING | NOTE: Take care not to scratch the fan | |||||
housing when installing the blade | |||||||
Turning off wall switch is not sufficient. | assemblies. |
|
| ||||
To avoid possible | electrical | shock, be | 3. Insert an | ||||
sure electricity is turned off at the main | |||||||
(supplied) into each of the two | |||||||
fuse or circuit breaker box before wiring. | |||||||
All wiring must be in accordance with | recessed holes in one of the blade | ||||||
National and Local codes and the ceiling | flanges. |
|
| ||||
fan must be properly grounded as a |
|
|
| ||||
precaution | against | possible | electrical | ! | WARNING | ||
shock. |
|
|
| ||||
|
|
|
| To reduce the risk of personal injury, do | |||
IMPORTANT: The side of the fan blade | not bend the blade flanges when | ||||||
having the rib line MUST be facing | installing the flanges, balancing the | ||||||
upward as shown in Figure 1. | blades or cleaning the fan. Do not insert | ||||||
|
|
|
| foreign objects between rotating fan | |||
1. Mount the fan blades to the blade | blades. |
|
| ||||
flanges using three | 4. Position the blade flange on the motor | ||||||
head screws and three flat washers | |||||||
(screws | and | washers | supplied) | hub so that the screws in the blades | |||
(Figure 1). |
|
| flange align with two threaded holes in | ||||
! | WARNING | the motor hub (Figure 2). Loosely | |||||
tighten the screws at this time. Repeat | |||||||
To reduce the risk of personal injury, do | this procedure for the remaining four | ||||||
blade assemblies. |
| ||||||
not bend the blade flange when installing |
| ||||||
|
|
| |||||
the blade flanges, balancing the blades or |
|
|
| ||||
cleaning the fan. Do not insert foreign |
|
|
| ||||
objects in between rotating fan blades. | REMOVE ONE PAN HEAD |
| |||||
|
|
|
|
| |||
|
|
|
| SCREW/LOCKWASHER | MOTOR FLANGE | ||
|
|
|
|
|
| ||
|
|
|
| ||||
RIB LINE (THIS SIDE | PAN HEAD |
|
| HEAD SCREWS (2) | |||
OF BLADE UP) | SCREWS (3) |
|
|
| |||
|
|
| FLAT |
|
|
| |
|
|
| WASHERS (3) |
|
|
| |
FAN BLADE
BLADE
FLANGE
Figure 1
BLADE
FLANGE
MOTOR HUB
Figure 2
5. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation.
5
