BP7305 Westfield 6/30/06 12:10 AM Page 7
11. Slip the longest pull chain through the hole in the large pendant (supplied) (Figure 5). Then secure the pendant by snapping the coupling (supplied) onto the end of the chain. Secure the small pendant (supplied) to the short chain in the same manner as above.
12. Carefully place the partially assembled ceiling fan on the lower styrofoam pad, with the switch cup assembly positioned in the opening and the blade assemblies resting on the outer rim of the styrofoam pad.
13. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 6). Remove th pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 20.
PIN
HANGER
BALL
DOWNROD
SETSCREW
The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 7) could result in the fan falling.
CLEVIS PIN
HAIRPIN 
CLIP
MOTOR
COUPLING
SETSCREW (2)
CANDELABRA BULB (4)
SOCKET
Figure 6
14. Unscrew the two upper setscrews (Figure 7) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 7). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin.
Figure 7
15. Tighten the two upper setscrews (Figure 7) securely while pulling up on the downrod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
16. Install four
17. Place the center glass on the rim of the fan motor and housing assembly; make sure the center glass is seated evenly in the housing flange (Figure 8).
7
