How to Put Your Ceiling
Fan Together
1.Pass the 42" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly.
2.Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly.
3.Loosen the two setscrews in the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 1). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling.
6.Mount the blade flanges to fan blades using three M5 x 6mm washer head blade screws per blade (Figure 2).
!WARNING
To reduce the risk of personal injury, do not bend the blade flanges when installing the flanges, balancing the blades, or cleaning the fan. Do not insert foreign objects between rotating fan blades.
M5 x 6mm WASHER
HEAD BLADE SCREW (3 Per Blade)
FAN BLADE
BLADE FLANGE
Figure 2
4.While pulling up on the hanger ball, securely tighten the two setscrews in the motor coupling (Figure 1).
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
5.The fan comes with blue, black and white leads that are 42” long. Measure up approximately 6 to
NOTE: Take care not to scratch fan housing when installing blades.
NOTE: Remove and discard the four shipping spacers and screws from the motor hub.
7. | Turn the fan assembly upside down in preparation |
| for mounting the fan blade assemblies. |
8. | Rotate the motor hub until the flange screw hole is |
| next to the cutout in the switch housing plate. |
| Attach the blade assembly to the motor hub using |
| the two M6 x 12mm flange head screws and |
| lockwashers (Figure 3). Make sure all screws are |
| tightened. Repeat this procedure for the other four |
DECORATIVE
CAP
HAIRPIN
CLIP
MOTOR COUPLING
HANGER BALL/DOWNROD ASSEMBLY
CEILING
COVER
SETSCREW
CLEVIS
PIN
blade assemblies. |
SWITCH HOUSING | BLADE FLANGE |
PLATE |
|
SETSCREW
Figure 1
MOTOR HUB | PREASSEMBLED M6 x 12mm |
FLANGE HEAD SCREWS WITH | |
| LOCKWASHERS (2) |
Figure 3
4 | U.L. Model No.: CF701 |
