BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 7
NOTE: The longer downrod (8”) furnished with the fan provides the minimum recommended floor to fan blade clearance for a 9 foot ceiling.
NOTE: The shorter downrod (4.5”) must be used for an 8 foot ceiling and can not be used with the decorative upper scroll.
DOWNROD
SETSCREW (2)
MOTOR COUPLING
8. Loosen the two setscrews in motor coupling if necessary. Separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the desired downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the 
clevis pin and secure with the hairpin clip (Figure 7). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.
Figure 8
10.Unscrew and remove one lockwasher and screw from each end of the upper light plate cover on the fan motor housing. Do not remove the screw closest to the light holes (Figure 9).
NOTE: The screw closest to the light holes, holds the light socket to the light plate cover. Do not remove this screw.
REMOVE SCREW AND
LOCKWASHER
UPPER LIGHT
REMOVE SCREW AND PLATE COVER
LOCKWASHER
DOWNROD
HAIRPINPIN |
CLIP |
SETSCREW (2)
CLEVIS PIN
MOTOR
COUPLING
MOTOR
COUPLING
Figure 7
9. While pulling up on the downrod, securely tighten the two setscrews in the motor coupling (Figure 8).
NOTE: The two setscrews must be properly installed as described above, or fan wobble could result.
| LIGHT HOLES |
HINGE | DO NOT REMOVE LIGHT |
Figure 9 | SOCKET SCREW |
|
11. Pull up on the upper light plate cover to expose the light socket. Place a 7- watt (maximum) candelabra base bulb (not supplied) into the light socket (Figure 10). Insert bulb into each of the remaining three sockets.
| |
UPPER LIGHT | CANDELABRA |
PLATE COVER | BASE BULB (4) |
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the two setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 6) could result in the fan falling.
Figure 10 | LIGHT | |
SOCKET | ||
|
12. Push the upper light plate cover down for each of the four light sockets and replace the lockwashers and screws previously removed in Step 10.
7
