BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 8
13. Slide the coupler cover on the downrod until it rests on the fan motor assembly (Figure 11).
DOWNROD |
| |
COUPLING | FAN MOTOR | |
COVER | ||
ASSEMBLY | ||
|
CEILING
COVER
8" DOWNROD
DECORATIVE
UPPER SCROLL
FAN MOTOR
ASSEMBLY
Figure 11 Figure 13
14. For Use With The 8” Downrod Only: Position the decorative upper scroll over the downrod. Slide scroll down onto the downrod until it rest on the fan motor assembly (Figure 12).
8" DOWNROD
DECORATIVE
UPPER SCROLL
16. Reinstall the hanger ball (Figure 14) on the downrod as follows. Route the motor leads through the downrod. Position the pin through the two holes in the downrod and align the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
FAN MOTOR ASSEMBLY
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
Figure 12
15. Place the ceiling cover over the downrod. Be sure both the ceiling cover, decorative upper scroll (use with 8” downrod only) and coupler cover are oriented correctly (Figure 13).
HANGER
BALL PIN
DOWNROD
Figure 14
CEILING
COVER
SETSCREW
17. The fan comes with blue, black and white leads that are 80” long. Before installing fan, measure up approx- imately 6 to
8