Emerson CF775BS02, CF775ORB02, CF775AW02 warranty Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper

One 5/16” open end wrench or pliers

Three wire connectors (supplied)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is com- pleted, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing assembly

c.Five fan blades

d.One ceiling cover

e.Five blade flanges

f.One hanger ball/downrod assembly

g.One hanger bracket

h.One coupling cover

i.One light fitter

j.One glass bowl

k.Three 60-watt (max.) candelabra bulbs

l.One loose parts bag containing:

1.Sixteen M5 x 6 slotted Phillips washer head blade screws

2.One M6 x 14 flange screw with lockwasher

3.Two wood pendants

4.Three wire connectors

5.Two threaded studs

6.Two lockwashers

7.Two knurled knobs

8.One clevis pin

9.One hairpin clip

10.Two couplings

11.Sixteen blade washers

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2. Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the top of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

C. FAN

BLADES

	I. LIGHT
UPPER	FITTER
FOAM
PAD
PROTECTIVE	A. FAN MOTOR
PLASTIC BAG	ASSEMBLY	J. GLASS
	E. BLADE	BOWL
	FLANGES
		G. HANGER
B. SWITCH		BRACKET
HOUSING		D. CEILING
ASSEMBLY		COVER
	F. HANGER BALL/
	DOWNROD ASSEMBLY
		L. LOOSE PARTS
		BAG
		H. COUPLING
		COVER
CARTON	LOWER
	FOAM PAD
		K. THREE 60-WATT
		CANDELABRA BULBS
3	U.L. Model No.: CF775-2