ICE FLASHER SERIES™ BASE ASSEMBLY

Perform the following high-level steps by following the instructionsin each numbered section to assemble the ICE Flasher Series™ base assembly:

1.Assembling the transducer storage posts

2.Assembling the base and handle

3.Assembling the control head to the base and handle

1. Assembling the Transducer Storage Posts

In this procedureyou will install the posts to hold the transducer cable.

Nut

 

Keyed Space of

 

Cable Retention Arm

 

Storage Post

Cable Retention

 

 

Arm, facing out

Spring

 

Flat Head Screw

 

1.Slide one spring over each flat-headscrew and set aside.

2.Insert a nut into the keyed space of each cable retention arm. Push down on the nut until it is flush with the surface of the cable retention arm.

3.Slide one cable retention arm over one storage post so that the arm faces out.

4.Hold the cable retention arm in place, and turn the base upside down.

5.Drop the assembled screw and spring straight into the back of the storage post. Using a flat-head screwdriver,push down on the screw, and tighten.

6.Repeat steps 2-5 for the second cable retentionarm.

6

Page 10
Image 10
Humminbird ICE 45, ICE 55, ICE 35 manual ICE Flasher Series Base Assembly, Assembling the Transducer Storage Posts