Fan Assembly Removal
Remove the fan assembly per the following steps.
1.Remove the system access cover (see Section 3, “Option Installation”).
2.At the rear of the system unit, press in on the two locking tabs securing the assembly to the chassis.
3.Remove the fan by pulling it outward away from the system board.
DIMM Module Removal
Remove any optional DIMM modules from the system board as follows.
1.Remove the system access cover and any expansion boards as previously described.
2.Press the locking clips at the ends of the socket away from the DIMM memory module (see the following figure).
3.Gently rock the module while pulling it up from the socket.
Removing a DIMM
A – Plastic Clip
When installing a DIMM module, align the notches on the module with the keys in the memory socket, insert the module, and press in the plastic locking clips.
Power Supply Removal
Remove the power supply as follows.
1.Remove the system access cover as previously described.
2.Label and unplug the power cable attached to the system board.
3.Label and unplug the power cables from all installed devices.
