J.Glass Panel Assembly
Removing/Replacing Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
•Remove three outer refractory pieces as per instructions in Section 15.L.
•Remove the lower decorative front face by removing the four screws attaching the face. See Figure 15.16.
•Remove the left and right refractory shields by removing the three screws holding each shield. See Figure 15.15.
•Remove the decorative firescreen mesh. Release the screen rod from the center screen support. Remove the right side of the screen rod from the
•Release glass latches (six in IDV4833, ten in IDV6247). Lift glass frame assembly forward past the glass latches. See Figure 15.9. Slide the glass to the right (into the cavity on the right).
•Completely remove the left side of the glass from the opening before sliding the entire glass panel from the unit. See Figure 15.10.
•Reverse steps above to replace the glass assembly.
Left
Refractory
Panel
Left |
|
| Glass |
|
| ||
Refractory | Glass Frame | Latches | |
Shield |
|
| |
Assembly |
|
| |
|
|
|
Front Hearth
RefractoryRight
Refractory
Shield
Decorative
Screen FrontScreen
Rod
Right
Refractory
Panel
Figure 15.8 Glass Panel Assembly Removal/Replacement
Figure 15.9 Lift Glass Frame Assembly Forward
Figure 15.10 Remove Left Side of Glass Frame First
48 | Heatilator • ICON |