Heatiator IDV4833IT Finishing, A. Mantel and Wall Projections, B. Facing Material, Mantels

14 Finishing

A. Mantel and Wall Projections

WARNING! Risk of Fire! Comply with all minimum clear- ances to combustibles as specified. Framing or finishing material closer than the minimums listed must be construct- ed entirely of non-combustible materials (i.e., steel studs, concrete board, etc).

Mantels

30 in. minimum

to ceiling

												17	18
											15	16	22-3/4
												22
										14
									13			21-1/4
											20-1/2
									12
								11		19-3/4
									19
							10
						9			18-1/4
					8			17-1/2
							16-3/4
					7	16
				6
					15-1/4
			5
		4			14-1/2
				13-3/4
		3	13
	2
		12-1/4
1
	11-1/2
10	10-3/4

Measured from top of fireplace opening (in inches)

Figure 14.1 Minimum Vertical and Maximum Horizontal Dimen- sions

Mantel Legs or Wall Projections

B. Facing Material

•Metal front faces may be covered with non-combustible materials only.

•Facing and/or finishing materials must not interfere with air flow through louvers, operation of louvers or doors, or access for service.

•Facing and/or finishing materials must never overhang into the glass opening.

•Observe all clearances when applying combustible materials.

•Seal joints between the finished wall and appliance top and sides using a 300°F minimum sealant. Refer to Figure 14.3.

WARNING! Risk of Fire! DO NOT apply combustible ma- terials beyond the minimum clearances. Comply with all minimum clearances to combustibles as specified in this manual. Overlapping materials could ignite and will inter- fere with proper operation of doors and louvers.

Finish wall material may be combustible - Top and Sides

	B	0 in.
A		Shaded area -
		noncombustible
		materials only
0 in.		0 in.

High Temperature Sealant (300° F/149° C min.)

Top of

Appliance

B

Drywall

A

Mantel Leg or Perpendicular Wall

Top and Side Seal Joint

Model		A	B
IDV4833	inches	44 3/8	46 1/2
	mm	1127	1181
IDV6247	inches	48 7/8	60 1/2
	mm	1241	1537

Figure 14.3 Non-combustible Facing Diagram

A1 in. (25 mm) min. to perpendicular wall

B7.75 in. (159 mm) min. from fireplace opening to perpendicular wall

Figure 14.2 Mantel Leg or Wall Projections (Acceptable on both sides of opening)

Heatilator • ICON DV-IDV Series • 4042-575 • Rev. S • 5/11 43