TEST AND FINISH THE INSTALLATION
Once you have assembled both the ICE Flasher Series™controlhead and the Ice Fishing transducer, and have routed all the cables, you should perform a final test. Testing should be performed with the transducer in the water.
1.After connecting the transducer to the control head, and confirming that the power cable is connected to the battery, drop the transducer into the ice hole to confirm proper operation.
WARNING: Before walking onto the ice, make sure that conditions are safe.
2. Turn the Power/Range dial to A (Auto) or x1 to
NOTE: If the unit does not power up, make sure that the connector is fully seated in the back of the control head, the power cable is connected to the battery, and the battery is charged.
3.If all connections are correct and power is available, the Humminbird® control head will enter Normal operation, and you should see the bottom on the control head display.
4.If the bottom is visible
NOTE: The transducer must be submerged in water for reliable transducer detection. The bottom of the transducer should be even with the bottom of the ice or hang slightly below the bottom of the ice.
16
