Emerson CF796CW0, CF796HGMO0 warranty Unpacking Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper
Three wire connectors (supplied).

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or acces- sories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing assembly

c.Five fan blades

d.One ceiling cover

e.Five blade flanges

f.One hanger ball/downrod assembly

g.One hanger bracket

h.One loose parts bag containing:

1.Sixteen 3/16-24 x 5/16” slotted Phillips blade screws

2.Sixteen blade washers

3.Eleven 1/4-20 x 1/2” Phillips oval head flange screws

4.One wood ball

5.Three wire connectors

6.Two threaded studs

7.Two knurled knobs

8.Two lockwashers

9.One clevis pin

10.One hairpin clip

11.One chain coupling

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retail- er or catalog outlet for replacement before pro- ceeding.

2.Remove the fan assembly from the protective plas- tic bag. Place the fan assembly into the upper foam pad with the bottom of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

UPPER

FOAM PAD

FAN

BLADES

	PROTECTIVE
	PLASTIC BAG	FAN ASSEMBLY
BLADE		HANGER
		BRACKET
FLANGES

CEILING

COVER

UPPER	HANGER BALL/
FOAM PAD	DOWNROD
	ASSEMBLY
	LOOSE
	PARTS BAG
	SWITCH
	HOUSING
	ASSEMBLY

CARTON

3