How to Put Your Ceiling Fan Together
1.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the clevis pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5.
PIN
HANGER
4.Make sure the grommet is properly installed in the coupling cover then slide the coupler cover on the downrod until it rests on the motor housing. Place the ceiling cover over the downrod. Be sure both the ceiling cover and the coupler cover are oriented correctly (Figure 3).
BALL 
SETSCREW
DOWNROD
Figure 1
2. Loosen setscrew in motor coupling if necessary. |
Separate, untwist and unkink the three 80” motor |
leads. Route the motor lead wires through the |
downrod. Align the clevis pin holes in the downrod |
CEILING
COVER
COUPLER
COVER
CLEVIS
PIN
SETSCREW 
MOTOR
COUPLING
Figure 3
CLEVIS
PIN
HAIRPIN CLIP
with the holes in the motor coupling. Install the |
clevis pin and secure with the hairpin clip (Figure |
2). The clevis pin must go through the holes in the |
motor coupling and the holes in the downrod. Be |
sure to push the straight leg of the hairpin clip |
through the hole near the end of the clevis pin until |
the curved portion of the hairpin clip snaps around |
the clevis pin. The hairpin clip must be properly |
installed to prevent the clevis pin from working |
loose. Pull on the downrod to make sure the clevis |
pin is properly installed. |
!
WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.
5.Reinstall the hanger ball (Figure 4) on the downrod as follows. Route the motor leads through the downrod. Position the pin through the two holes in the downrod and align the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
PIN
HANGER
BALL 
SETSCREW
DOWNROD
SETSCREW
CLEVIS PIN
Figure 2
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
CEILING COVER
Figure 4
6. The fan comes with blue, black and white leads |
that are 80” long. Before installing fan, measure up |
approximately 6 to |
ball/downrod assembly. Cut off excess leads and |
strip back insulation |
3.While pulling up on the downrod, securely tighten the setscrew in the motor coupling (Figure 3).
NOTE: The setscrew must be properly installed as described above, or fan wobble could result.
7. Turn fan assembly upside down in preparation for |
mounting fan blade assemblies. |
4 | U.L. Model No.: CF955 |
