Wiring Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
!WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
THREADED STUD 
NOTE: If you are not sure if the outlet box is ground- ed, contact a licensed electrician for advice, as it must be grounded for safe operation.
#8 LOCKWASHER
KNURLED KNOB
Figure 10
CEILING COVER
1.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation) (Figure 9). Securely connect the wires using wire connector supplied.
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
BLACK AND BLUE FAN WIRES
GROUND WIRE
LISTED
WIRE
CONNECTOR (3)
GREEN WIRE (GROUND) FROM HANGER BRACKET
GREEN WIRE (GROUND) FROM HANGER BALL
Figure 9
NOTE: CEILING COVER
OMITTED FOR CLARITY.
WHITE SUPPLY (NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY (HOT)
THREADED
STUD (2)
Final Assembly of the
Ceiling Fan
1.Mount the blade flange to the blade using three
M5 FLAT WASHER (3)
BLADE
2.Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector supplied (Figure 9). Securely connect the fan motor black wire and blue wire to the supply black (hot) wire using wire connector supplied (Figure 9). After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.
3. Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 9).
4. Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 10).
5.Secure the ceiling cover in place by sliding #8
lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 10). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod.
BLADE FLANGE
Figure 11
2.Install one blade assembly to the motor hub using two
BLADE
ASSEMBLY
6Figure 12
