Emerson CF960WB 00, CF960CK 00, CF960BS 00 owner manual Coupling Adapter

3.Partially install two 3/16-24 x 1/4” Phillips round head screws in two of the tapped holes in the coupling adapter (Figure 13). Leave two or three threads untightened.

IMPORTANT

If you intend to install your ceiling fan without using the light fixture supplied with the fan, or if you are going to use a different Emerson light fixture with your fan, proceed to “Installation of Light Adapter Plate” Section on page 8.

COUPLING

ADAPTER

3/16-24 x 1/4" PHILLIPS ROUND HEAD SCREWS (2)

Figure 13

4.Position the keyhole slots in the light fixture mount- ing plate over the two screws in the coupling adapter (Figure 14). Rotate the mounting plate clockwise to engage the slots under the screw heads, then install a 3/16-24 x 1/4” Phillips round head screw in the remaining tapped hole in the coupling adapter. Tighten the two screws securing the keyhole slots.

LIGHT FIXTURE

MOUNTING PLATE

2 INSTALL 3/16-24 x 1/4" PHILLIPS ROUND HEAD SCREW

3 TIGHTEN TWO 3/16-24 x 1/4"

PHILLIPS ROUND HEAD SCREWS

1 ROTATE MOUNTING PLATE CLOCKWISE

Figure 14

RECESSED

PORTION OF

MOUNTING

PLATE

PROVIDES

CLEARANCE

FOR LIGHT

FIXTURE

SWITCHES

LIGHT FIXTURE

MOUNTING PLATE

LIGHT FIXTURE

ASSEMBLY

MOTOR CONNECTOR

LIGHT FIXTURE

CONNECTOR

Figure 15

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are not pinched between the light fixture assembly and the mounting plate.

6.Position the light fixture assembly over the light fixture mounting plate. The light fixture switches must be located in the recessed portion of the mounting plate (Figure 15). Align the holes in the light fixture with the holes in the mounting plate and install four 5/32-32 x 5/16” Phillips flat head screws (Figure 16). Carefully screw in the 75-watt halogen flood lamp (supplied).

7.Cut the speed control switch and light control switch pull chains to your desired length (optional). Connect the wood pendant (supplied) to one pull chain by sliding the wood pendant (small hole first) onto the pull chain (Figure 16). Then attach a chain coupling (supplied) to the end of the chain and allow the pendant to slide down over the coupling. Repeat this procedure for the other pull chain.

LIGHT FIXTURE	5/32-32 x 5/16" PHILLIPS
SWITCHES
	FLAT HEAD SCREW (4)

LIGHT

FIXTURE

ASSEMBLY

5.Engage the connector from the light fixture assembly with the motor connector (Figure 15). The two connectors are keyed and color-coded and must be mated correctly (color-to-color) before they

can be engaged. Make sure the connector latch closes properly.

7 Figure 16

WOOD PENDANT

CHAIN COUPLING