Emerson EWC19T4 Installing the Batteries, Connecting to External Input Jacks, External Input Mode

TO RECORD A SCRAMBLED/UNSCRAM- BLED CHANNEL

INSTALLING THE BATTERIES

1.Set the unit’s channel selector to the output channel of the Cable Converter Box or Satellite Box (Ex. CH3).

2.Select the channel to record from your Cable Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV sys- tem installer’s attention to Article 820-40 of the NEC that provides guidelines for proper ground- ing and in particular, specifies that the cable ground shall be connected to the grounding sys- tem of the building as close to the point of cable entry as practical.

CONNECTING TO EXTERNAL

INPUT JACKS

When you watch a program recorded on another source (VCR or video camera), use the AUDIO/ VIDEO input jacks on the front panel.

Connect the audio/video output jacks of another source to the AUDIO L/R and VIDEO jacks of this unit.

Then press the CHANNEL button K or L until “AUX” appears on the screen.

NOTE:

•When you connect a monaural VCR (another source) to this unit, connect the Audio output jack of the monaural VCR (another source) to the AUDIO L jack of this unit. The audio will output in both L and R channel equally.

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 “AA” penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

EXTERNAL INPUT MODE

When using an external input signal (another VCR or video camera), connect the player’s audio/video out- put cables to the AUDIO L/R IN/

VIDEO IN jacks of your unit. Then AUX press the CHANNEL button K or

Luntil “AUX” appears on the screen.

[Another source]

etc.

To the audio output jacks

Audio/Video cable

(not supplied)

[Front of the unit]

To the video output jack

[Fig. 5]

- 12 - EN

1C29