–13 –EN
1L25

CONNECTING TO ATV

ANT-IN
ANT-OUT
VIDEO OUT
AUDIO OUT S-VIDEO
OUT AUDIO
OUT
DIGITAL
AUDIO OUT
COAXIAL
Y
Cb
Cr
L
R
COMPONENT
VIDEO OUT
AUDIO IN
VIDEO IN
DVD/VCR VCR DVD
R
L
To VIDEO OUT jack
To VIDEO INPUT jack
To Right (red) and Left (white)
Antenna/Cable signal
To ANT. IN
of TV
To AUDIO INPUT jacks To AUDIO OUT jacks
A/V-compatible or
wide screen TV
[Fig. 1]
Notes
¡Connect the DVD/VCR COMBINATION UNITS directly to a TV. If the A/Vcables are connected to a
VCR, pictures may be distorted due to the copy protection system.

DVD/VCR TO TV CONNECTION

1. Disconnect the AC power cord of the TVfrom the
AC outlet.
2. Disconnect the antenna or cable from the TV.
3. Connect the antenna or cable to the ANT-IN jack of
the DVD/VCR COMBINATION UNITS.
4. Connectthe DVD/VCR COMBINATION UNITS to
the TVusing the RF cable.
5. Plug the AC power cords of the DVD/VCR COM-
BINATION UNITS and TVinto the AC outlets.
UHF/VHF
ANT-IN
ANT-OUT
VIDEO OUT
AUDIO OUT
AUDIO IN
VIDEO IN
DVD/VCR VCR
R
L
[VHF/UHF
combination antenna] [Back of the DVD/VCR]
IN OUT
[Cable box or satellite box]
OR
[Indoor antenna] [Back of the
UHF/VHF combination TV]
RF cable
(supplied)
From Cable or
Satellite Company
OR
Note to CATVsystem installer
This reminder is provided to call the CATVsystem installer’s attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected
to the grounding system of the building, as close to the point of cable entry as practical.
HOOKUPS
CAUTION:
¡Be sure to turn off the DVD/VCR COMBINATION UNITS and equipment to be connected before connecting.
¡Read through the operation manual for the equipment to be connected.
¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.
¡Be sure to keep the DVD/VCR COMBINATION UNITS connection cables separate from the TVantenna cable
when you install the DVD/VCR COMBINATION UNITS, because it may cause electrical interference when
you are watching television programs.
If yourTV does not have A/V terminals:
1. Connect the DVD/VCR COMBINATIONUNITS
to a TVusing RF cable (see DVD/VCR TO TV
CONNECTION).
2. Select channel 3 on your TV.
3. Press PLAY.
¡If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAYfor 3 sec-
onds during playback.
¡There is case that the RF output channel does not
change by situation (For example, when you adjust
tracking using CHANNEL(UP/DOWN)).
In this case, stop the playback, and start the play-
back again. After that, press PLAYon the VCR for
3 seconds.
¡If there is a power failure or the DVD/VCR COM-
BINATION UNITS is unplugged for more than 30
seconds, the RF output channel setting will return to
CH3.

RF OUTPUT CHANNEL

H9410UD(EN).qx33 03.1.17 6:21 PM Page 13