Emerson LD195EM8 7 Watching TV, 5Channel Selection, 5Switching Each Input Mode, Analog Mode

WATCHING TV

5Channel Selection

Select channels by using [CH. K / L] or [the Number buttons].

Use [CH. K / L] or [the Number buttons] to select the memorized channels.

or or

Using [the Number buttons]

TV

- When selecting analog channel 12

DTV

- When selecting digital channel 12-1

•Be sure to press [–/ENT.]before entering the minor channel number.

•Press [CH. RECALL ] to return to the previously viewed channel.

•When you select a channel larger than 100, press [+100] first. Then use [the Number buttons] to press the lower 2-digit numbers.

•Only [the Number buttons] can be used to select the non-memorized channels.

About digital TV broadcasting:

With its high definition broadcast, digital broadcasting far surpasses analog broadcasting in both its picture and sound quality.

What is the minor channel?

By using high compression technology, digital broadcasting offers a service that enables multiple signals to send simultaneously. Therefore, you can select more than one program per major channel since digital broadcasting technology distinguishes between multiple channels broadcast by a single network.

5Volume Adjustment INTRODUCTION

This section describes how to adjust the volume.

The mute function, which turns the sound off and on, is also described.

Use [VOL. X / Y] to adjust the audio volume.			PREPARATION
or
	VOLUME	20
			INITIAL
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.			SETTING
• The volume bar will automatically disappear in a few
seconds.

Press [MUTE] to turn off and on the sound.

MUTE 20 WATCHING TV

• “MUTE” is displayed on the TV screen.

Press [MUTE ] again or use [VOL. X / Y] to recover	OPTIONAL
the original volume.	SETTING

5Switching Each Input Mode	OPERATING
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access external devices when they are connected to the unit.
Press [INPUT] repeatedly to cycle through the input	DVD
modes.
ANALOG MODE

NTSC (analog mode) [Air Time] 18:00

	18:30
CH4	19:00
	19:30
	20:00
	20:30

ATSC (digital mode)

CH4	No signal	No signal
	CH4
(high definition		TV)
CH4	CH4-1	No signal
CH4	No signal	CH4-2
CH4	CH4-1	CH4-2

	DIGITAL MODE	DVD
		SETTING
	VIDEO1
	VIDEO2
	PC
		TROUBLESHOOTING
• To use the video or S-video input jack on the unit,
select “VIDEO1”.
• To use the component video input jacks on the unit,
select “VIDEO2”.

major channel minor channel

: change automatically

: change manually by using [CH. K/L]

Although, you cannot watch the high definition TV (HDTV) program, the unit converts the HDTV signal down to the standard definition TV signal.

Note:

•“NO SIGNAL” will appear on the TV screen after the minor channel broadcast is over.

• To use the PC input jack on the unit, select “PC”.
Note:	INFORMATION
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. “NOW SCANNING“ is displayed while switching
the modes.
15
EN