5.1 Analyzer Module Setup

5.1.18 Inputs and Outputs (Local SIO/DIO)

Main Menu — Analyzer and I/O-module expert configuration

↓

Analyzer module setup

↓[2nd menu page via F5 (More...)]

Inputs and outputs

↓

TAG

95.00 ppm

-- Analyzer Module I/O-Modules --

SIO-01 module...

DIO-module(s)...

Measure

 

<<<

Back...

>>>

F1

F2

F3

F4

F5

From the menu "Analyzer Module I/O-Modules" you can change to several submenus, where you can set up the parameters of the local SIO module or the local DIO modules of an MLT analyzer module:

¨Press the 8 -key or the → -key in the line "SIO-01 module..." or "DIO-module(s)..." to change to the corresponding submenus

Notes:

¨If there is no local I/O module in the analyzer module, you will see a corresponding note on the display instead of the menu page shown above.

¨If you want to set up the auxiliary SIO or DIO modules, you have to go to the submenus of the menu "I/O Module Controls" (see 5.2 p. 5-83).

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

5 - 67