Emerson NGA 2000, NGA2000 manual 109

6 Technical Level Configuration

If you press the ENTER key or the → -key in the line "Technical level configuration..." of the "Main Menu" you will change to the following display:

CLD				95.0 ppm
	Technical configuration menu
System set up...
Service menus...
Diagnostic menus...
Other module diagnostic menus...
Listing of all modules...
MAIN		NEXT		INFO
F1	F2	F3	F4	F5

From the menu "Technical level configuration" you can change to several submenus to set up the system parameters of the platform, of the analyzer or of the analyzer module. Besides you can set up or control the software and hardware configuration of the control module or of the analyzer modules. Some of the system parameters in chapter 6 you can also set up in several submenus of the expert controls (chapter 5.4 p. 5-47to 5-52).

In the following table you will find a short overview about the contents of the menus and where you will find their description in this manual:

Menu	Important Contents		Chapter in this manual
System set up...	Þ	Configuration of the LCD-screen	* 6.1 p. 3 to 16
		and front panel control
	Þ	Binding of uncategorized I/O
		modules with the platform
	Þ	Setup of security codes of the
		different operating levels
Service menus...	Þ	Manufacturing and service data	* 6.2 p. 17 to 24
		of the control module and the
		analyzer modules
Diagnostic menus...	Þ	Error messages of the control	* 6.3 p. 25 to 43
		module software and of the
		analyzer modules software
Other module diagnostic	Þ	not available at the moment;	*	6.4 p. 44
menus...		reserved for error messages of
		"none-NGA-modules" software
Listing of all modules...	Þ	Overview of all modules	*	6.5 p. 45
		connected to the platform

or the MLT analyzer

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000 6 - 1