Emerson NGA 2000, NGA2000 manual 49

5 Expert Controls and Set up

If you press the ENTER key or the → -key in the line "Expert controls and set up..." of the "Main Menu" you will change to the following display:

CLD						95.0 ppm
			Expert controls and set up
Expert analyzer controls...
Auxiliary module controls...
System set up...
Analyzer module set up...
Auxiliary module set up...
System calibration...
MAIN	<<<			NEXT		INFO
F1	F2	F3	F4	F5

From the menu "Expert controls and set up" you can change to several submenus to set up parameters for the measurement and calibration of your analyzer and analyzer module. Besides you can set up the configuration for auxiliary modules. Which part of these menus are important for you depends on the configuration of your NGA 2000 system.

In the following table you will find a short overview about the contents of the menus and where you will find the description in this manual:

Menu	Important Contents		Chapter in this manual
Expert analyzer	Þ	Zero/Span calibration	* 5.5 p. 53 to 60
controls...	Þ	Range settings
	Þ	Ozonator power
Auxiliary module	Þ	Configuration of the SIO and of	* 5.2 p. 29 to 44
controls...		the DIO's installed in a platform
		or in an MLT analyzer
System set up...	Þ	Front panel control	* 5.4 p. 47 to 52
	Þ	Set up of the
		single component display
	Þ	Display resolution
Analyzer module set up...	Þ	Measurement/Calibration	* 5.1 p. 3 to 28
		parameters set up
	Þ	Linearizer parameters set up
	Þ	Sensor/Converter/Block
		parameters set up and
		optimization
Auxiliary module set up...	Þ	Set up for micro processor	*	5.3 p. 45
		controlled auxiliary I/O modules
System calibration...	Þ	Zero gas and span gas	*	See Supplement!
		calibration of all channel

automatically

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000 5 - 1