5.1 Analyzer Module Set up

Main Menu — Expert controls and set up

↓

Analyzer module set up

↓

CLD

95.0 ppm

Analyzer module set up

Calibration gas list...

Calibration parameters...

Gas measurement parameters...

Analyzer parameter list...

 

 

 

Physical measurement parameters...

 

 

Displayed parameters...

 

 

 

Analyzer tag:

 

 

CLD

HOME

ESCAPE

 

 

INFO

F1

F2

F3

F4

F5

From the menu "Analyzer module set up" you can change to several submenus, where you can set up the measurement and calibration parameters of the CLD analyzer module. Besides, you can go to those submenus where you can set up the parameters of the single component display.

Caution:

Normally, you will find "CLD" as analyzer module tag in the line "analyzer tag".

If the CLD module is part of an analyzer network: You have to change the configuration of the programmable digital inputs and analog outputs, if you change the identification tag ! Because, the parameters of the module source will change ! So, the relations will disappear !

Set up parameters:

¨Select the menu line you want or the line of variables "Analyzer tag" with the ↓ -key or the − -key.

¨Select the variable or change to the submenu with the ENTER key or the → -key.

¨Select any digit with the ← -key or the → -key and adjust a new value with the − -key or the ↓ -key;

Maximum of digits: 30

Options: alphabet (capital and small letters), umlauts, letters from different languages, 0, 1, 2, ..., 9, +, -, *, /, =, ?, !, %, $ and many others.

¨Confirm the new value with the ENTER key or cancel and go back to the last value with the F2 key.

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000

5 - 3