Emerson NGA 2000, NGA2000 manual 65

"Gas measurement units" "Pressure measurement units" "Temperature measurement units" "Conversion factor ppm – mg/Nm3"

5.1.7 Analyzer Module Set up

Units

Main Menu — Expert controls and set up

					↓
		Analyzer module set up
					↓
		Gas measurement parameters
					↓
				Units
					↓
CLD							95.0 ppm
			Units
Gas measurement units:								ppm
Pressure measurement units:								hPa
Temperature measurement units:								C
ppm to mg/Nm3 conversion factor:							1.000
Variables are still sent as the basic SI unit.
HOME	ESCAPE						INFO
F1	F2		F3	F4	F5

In the menu "Units" you can set up the units of the analyzer for pressure, temperature and gas concentration.

Set up parameters:

¨Select any line of variables with the ↓ -key or the − -key.

¨Select the variable with the 8 -key or the → -key.

¨Select any digit with the ← -key or the → -key and adjust a new value with the − -key or the ↓ -key

resp. select the whole parameter with the − -key or the ↓ -key.

Options:ppb, ppm, mg/Nm3, % hPa, psig

C, F

0 to 100

¨Confirm the new value with the ENTER key or cancel and go back to the last value with the F2 key.

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000 5 - 17