Emerson SST1000, SST2000, SST1400, SST1600 manual Preinstallation, Locating the AIR Filter

PREINSTALLATION

Not to Exceed 20

Air Flow

Furnace	Air Flow
Opening
	Electronic
	Air Cleaner
	Opening
Furnace	Electronic
Transition Section	Air Cleaner
(if Needed)

Figure 3

LOCATING THE AIR FILTER

Your air filter must be mounted in the return air duct of a central forced-air system, on the air entering side of your furnace. (See Figure 3 for example.)

(Interchangeable)	(Interchangeable)
Collecting Cell	Collecting Cell

Cabinet	Outlet Box
	Power Pack
	Handle

Contact
Button	Contact
Pre-Filters
	Button
(Interchangeable)		See text for Cell

Removal Clearance

Figure 4

	Knockouts for
6 7/8"	3/4" Conduit
	(three sides)

Select a location that meets the following:

1. The face of the cell will be at a right angle to the air

stream.

E

CF

2.	Allow the following clearances to permit removal of
	cells and pre-filters: (See Figures 4 and 5)
	Model SST1000 - 14 inches
	Model SST1400 - 15 inches
	Model SST1600 - 14 inches
	Model SST2000 - 15 inches
	For complete dimension data refer to Figure 5.
3.	The air filter is not to be placed in the discharge of
	either the heating or cooling unit.
4.	IMPORTANT: If atomizing spray type humidifier is
	used, it must be installed downstream from the air
	filter.
5.	If the air cleaner has a power cord installed, unit must
	be located close enought to the outlet so connection
	can be made without the use of an extension cord.

If your furnace duct system has a pre-installed boot, discard front cover of boot and slide the air cleaner component inside the boot. For installation of Air Cleaner Retrofit (ACR) kits, see page 13.

If furnace opening cannot be enlarged to required size, a transition sheet metal section must be used. Transition must be planned for each job. Reduction should not be more than 4 inches per linear foot, approximately 20 angular degrees (Figure 3).

D

B

A

MODEL NO.	A	B	C	D	E	F
SST1000	24 3/4	21 5/16	18 5/8	13 9/16	16 7/16	19 1/16
SST1400	29 11/16	26 1/4	23 5/8	13 9/16	16 7/16	19 1/16
SST1600	25 1/2	21 5/16	18 5/8	17 3/4	20 5/8	23 3/8
SST2000	29 11/16	26 1/4	23 5/8	17 3/4	20 5/8	23 3/8

Figure 5

DIRECTION OF AIR FLOW THROUGH

THE AIR CLEANER

Your air cleaner is shipped from the factory with air flow from left-to-right. If this air flow is suitable for the installation, no further changes need to be made (Fig- ure 4). For right-to-left air flow, remove both pre-filter and cell sections. Turn cells upside down (with the same end facing the cabinet opening). This will locate the ionizing wires at the right, and both contact buttons and cell handles will be facing the power door. Air flow direction must agree with arrow embossed on end of collecting cells.

After installing the cell sections, install pre-filters in cabinet tracks on the right. This will again place the pre-filters on the air entering side (on the same side as ionizing wires).

4