Mounting the Sensor | Emerson Process Management T-SERIES instruction

Mounting the Sensor

Step 3 Mounting the Sensor

Use your common practices to minimize torque and bending load on process connections. To reduce the risk of condensation or excessive moisture, the conduit opening should not point upward (if possible). The conduit opening of the junction box or core processor can be rotated freely to facilitate wiring.

Figure 7 illustrates how to mount the sensor. Do not use the meter to support the piping.

Figure 7 Mounting a T-Series sensor

Page 11

Image 11

Emerson Process Management T-SERIES installation manual Mounting the Sensor, Mounting a T-Series sensor

Contents

Micro Motion Series Sensor Page Before You Begin Customer serviceTroubleshooting Specifications Purge plugs European installationsInstallation options Definitions Series sensor with core processor Environmental limits Hazardous area installationsDetermining a Location Full flow tubes UL and CSA ambient temperature limits Series sensor ambient and process temperature limits Valves Maximum wiring distancesMaximum cable lengths Pipe run Hygienic applications Orienting the SensorSelf-draining applications Flow direction arrow Eccentric reducer Mounting a T-Series sensor Mounting the Sensor Core processor to a 4-wire remote transmitter Wiring Wrapping the shield drain wires Applying the heat shrink Connecting the wires at the core processor Removing a purge plug Case purging procedureGrounding Purge Fittings Purge rate Time Sensor model Time required to purge T-Series sensor cases Used equipment Return PolicyNew and unused equipment Page 20002172

Emerson Process Management T-SERIES Mounting the Sensor, Mounting a T-Series sensor

Models: T-SERIES

Step 3 Mounting the Sensor

Figure 7 illustrates how to mount the sensor. Do not use the meter to support the piping.

Figure 7 Mounting a T-Series sensor