Emotiva LPA-1 Emotiva LPA-1 Seven Channel Ampli er, Front Panel Layout

Page 9

Emotiva LPA-1 Seven Channel Ampli er

• Audiophile quality seven channel multi-channel power ampli er.

• Six 125 watt channels of ampli cation (one channel is con gurable for two channel operation)

• Low noise 1.2 KVA torrid power transformer

• Complementary, discrete power ampli er design incorporating high current, high speed, Toshiba

power devices

• Channel status indicators for standby, operate, and fault

• Con gurable power output as follows: 125 watts/8 ohms x 6 channels or 125 watts/8 ohms x 5

channels plus 2 x 50 watts/8 ohms x 2 channels

• Completely stable into 4 ohm loads

• Signal to Noise Ratio is greater than 100dB, unweighted ref. full output

• THD .03% at rated power, 20Hz – 20kHz

• Fully protected from all fault conditions

• Soft start circuitry

• External trigger turn on

• Soft touch power switch

• 4RU chassis w/ solid milled aluminum faceplate

• IEC power inlet, 120/230 VAC con gurable

Front Panel Layout

Front Panel LED Display

The front panel display contains informative LED lighting to indicate the condition of the LPA-1.

NO LED

Amplifier is OFF

BLUE LED

Normal Operation

FLASHING RED LED

= Fault Condition

See “Troubleshooting” section for details.

Front Panel Power Switch

This switch provides the ON/OFF control of the

LPA-1 from the front panel. When the unit is

off and in standby mode, the switch illuminates

yellow. Automatic switching is accomplished

with the 3.5mm trigger input on the back panel

using a 3-12VDC control signal.

Rubber Feet

These rubber feet keep the LPA-1 elevated for bottom ventilation as well as for vibration isolation.