Emotiva LPA-1 manual Rear Panel Layout, Channels 6 and 7 Bridged

Rear Panel Layout

RCA Audio Inputs	Master Power Switch
These inputs provide the signal information	This rocker switch provides the master power
for each channel on the LPA-1. Simply	for the LPA-1. After it is in the ON position, the
connect them to the appropriate output of the	amplifier can be turned on manually from the
preamplifier/processor or other preamp level	front panel switch or automatically with the
audio device. Channels 6 and 7 (far left) can	trigger input via 3.5mm input jack.
be used as a bridged output, in which case it
only requires an input from channel #6

Remote Turn On Jack	Speaker Outputs (5 way Binding Posts)
This 3.5mm jack accepts a 3-12 volt input for	These are the speaker outputs. The 5 way
remote activation of the LPA-1. This mates	binding posts accept stripped speaker wire,
directly with the Emotiva LMC-1 trigger output	banana plugs (single or dual), or spade
and supplied cable. If building your own cable,	connectors. Be sure to observe correct polarity
center is positive and outer shield is negative.	when connecting speakers and be sure that
	the wires do not touch between positive and
Channels 6 and 7 Bridged	negative terminals.
	When bridging channels 6 and 7 to a passive
	(non powered) subwoofer system, refer to the
	diagram at left.

Power Receptacle Standard IEC 3 prong power receptacle. It is advised that this amplifier have a direct

connection to a wall outlet. Do not plug into a “power strip”.

Page 10