Inserting the EPM-300 Module
CAUTION: Make sure the MPS-1 chassis is NOT CONNECTED to line voltage during the installation of the power modules!
1Gently align the rails and slide the
Power Module into place
2Once installed, attach (4) #2 Phillips screws to secure the
Power Module
1
Single Nylon Rail
(Top)
FrontMPS-1 Chassis
| 2 | |
| | For proper installation of the power module, the |
| | nylon rail guides must be aligned with the metal rails |
| Back | channels inside the MPS-1. There is very little tolerance in |
| the design for misalignment, so installation should be somewhat |
| |
| | easy if you have the module configured correctly. Begin to insert the |
power module into the MPS-1 chassis. Insertion of the power module is smooth and easy and it will not require any excessive force. If you must force the power module in, stop and re-evaluate your alignment of the nylon guide rails. Excessively forcing the power module can damage it. Use care not to damage the fan or electronic components during this installation. The power module is fully inserted when it bottoms out in the back of the MPS-1 chassis.
Completing the EPM-300 Installation
Once the power module is inserted, you must attach it to the MPS-1 chassis with four #2 phillips screws (provided). The screw holes on the back panel should line up to threaded holes in the MPS- 1 chassis. Install and tighten the screws, then proceed with the installation of subsequent power modules.
Once the installation of all power modules is completed, use the supplied CHANNEL I.D. decals to identify each power module for easy channel identification.
Page 17