Emotiva manual MPS-1Installation Accessories

MPS-1 Installation Accessories

The MPS-1 Modular Power Amplifier comes with some additional installation accessories that make the component fit into virtually any installation theme.

Piano Black Wood Side Panels

The MPS-1 comes with attractive wood side panels in a stunning piano black lacquer finish. As this electronic component is going to be in many homes alongside equally nice furniture, the side panels allow the MPS-1 to look a little more like it belongs in the room. Although every installation will not require them, they are included for the owner to use if he/she so chooses.

To clean the piano black finish, simply use a damp cloth (dampened with water) and wipe them down. Then use a soft dry cloth to dry and buff the finish to its original shine. Do not use any chemicals on the side panels. Chemical cleaners may cloud the finish of the laquer.

Rack Mount Installation Hardware

In the event the user chooses to mount the MPS-1 in a“rack mount”configuration, the unit has rack mount ears included. To install the MPS-1 into a rack mounting configuration, the following details must be completed.

1)The piano black wood side panels must be removed, This is accomplished by simply removing the four #2 Phillips screws on each panel.

2)The four aluminum feet of the MPS-1 chassis must also be removed. This is accomplished by re- moving one #2 Phillips screw directly in the center of the foot

3)Remove two #2 Phillips screws attached at the front edge of the side panel.

4)Attach the rack mount ears to the side panels using the longer #2 Phillips screws provided.

5)When installing into a rack mounting position, be sure to provide adequate support from the sides and/or rear of the unit to avoid any unnecessary stress on the chassis.

6)Be sure the MPS-1 has adequate ventilation. At least 1 empty rack space above AND below the chassis will allow fresh air to circulate around the unit.

Page 18