Flush Wall Installation

FINISHED WALL

3! OF NON-COMBUSTIBLE MATERIAL

FRONT TRIM OR NON- COMBUSTIBLE MA TERIAL (INSTALLA TION IS OPTIONAL)

JOINT BETWEEN FINISHED

WALL AND UNIT SEALED

WITH 300° F, 149° C SEALANT

MATERIAL (SEALANT IS OPTIONAL)

Figure 12

Combustible Surround Installation

Attention:Coldclimateinstallationrecommendation:

When installing this unit against a non-insulated exterior wall, it is mandatory that the outer walls be insulatedtoconformtoapplicableinsulationcodes.

Vent Runs (Figures 14, 15, 16, 17 and 18)

In planning the installation for the fireplace, it is necessary to install certain components before the appliance is completely positioned and installed. These include the direct vent system, gas piping for the appliance and the electrical wiring. (If the fan option is used.)

The appliance can be mounted on any of the following surfaces:

1.A flat, hard combustible (burnable) surface.

2.A raised wooden platform.

3.Four (4) corner supports. (Example: Four (4) concrete masonry blocks.) These supports must be positioned so they contact all four (4) perimeter edges on the bottom of the unit.

VERTICAL, 90° ELBOW WITH HORIZONTAL

TERMINATION

2 X 4 HEADER

STAND OFF

MANTELSHELF

COMBUSTIBLE SURROUND

FINISHED WALL

3! OF NON-COMBUSTIBLE MATERIAL FRONT TRIM OR NON-COMBUSTIBLE MATERIAL (INSTALLATION IS OPTIONAL)

JOINT BETWEEN FINISHED WALL AND UNIT SEALED WITH 300° F 149° C SEALANT MATERIAL (SEALANT IS OPTIONAL)

DVP42, 48

49 ½”(126 mm)

TO BOTTOM

OF UNIT

VENT CAP/

THIMBLE

/

THIMBLE

Figure 14

Figure 13

Page 12

17375-6-0705

Page 12
Image 12
Empire Comfort Systems DVP48FP3, DVP48FP9, DVP42FP9, DVP48FP7 Flush Wall Installation, Combustible Surround Installation